Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
getting-started:setting-up-devices [2017/07/24 22:05]
Elco Jacobs [Setting up devices]
getting-started:setting-up-devices [2017/07/25 08:44] (current)
Elco Jacobs
Line 32: Line 32:
 When installing a device, you can pick any free slot. The slot is just a storage location in software. It does not have any relation to the hardware location. When installing a device, you can pick any free slot. The slot is just a storage location in software. It does not have any relation to the hardware location.
  
-First set up your temperature sensors. For a typical fridge setup, you will set up one sensor as assigned to`Chamber 1``Beer 1with function ​`Beer Tempand another sensor as `Chamber 1``Chamber devicewith function ​`Chamber Temp`. Additionally,​ you can configure 3 sensors for logging (`Chamber 1``Chamber device``Log 1/2/3 temp`.+First set up your temperature sensors. For a typical fridge setup, you will set up one sensor as assigned to''​Chamber 1''​''​Beer 1'' ​with function ​''​Beer Temp'' ​and another sensor as ''​Chamber 1''​''​Chamber device'' ​with function ​''​Chamber Temp''​. Additionally,​ you can configure 3 sensors for logging (''​Chamber 1''​''​Chamber device''​''​Log 1/2/3 temp''​.
  
-Next, set up your heater and cooler. Find the actuator you want to assign in the list (Bottom 1/2 or Top 1/2/3), pick a free slot and assign them as `Chamber 1``Chamber device``Chamber Heater`Chamber cooler`. Leave the pin type to `not inverted`.+Next, set up your heater and cooler. Find the actuator you want to assign in the list (Bottom 1/2 or Top 1/2/3), pick a free slot and assign them as ''​Chamber 1''​''​Chamber device''​''​Chamber Heater'' ​''​Chamber cooler''​. Leave the pin type to ''​not inverted''​.
 Additionally,​ you can set up devices as manual actuator. You can toggle a manual actuator by pressing the ON/OFF buttons in the device list. Additionally,​ you can set up devices as manual actuator. You can toggle a manual actuator by pressing the ON/OFF buttons in the device list.